Inside Sabertooth
Learn how Sabertooth uses 3ds Max to create 3D interactive projects, including HBO Go’s Game of Thrones interactive experience
  • 1/3
You are here: Forum Home / Autodesk® MotionBuilder® / Autodesk MotionBuilder 2011 / Physics joint chain question...
  RSS 2.0 ATOM  

Physics joint chain question...
Rate this thread
 
55959
 
Permlink of this thread  
avatar
  • Total Posts: 8
  • Joined: 21 December 2009 09:54 PM

Hi, I am trying to make a necklace type of joint chain using bones in Motionbuilder.  I am able to make a rope type of joint chain simulation (like the tiger tail in KxL’s vids) but I can’t seem to figure out how to make one in a loop form or having both ends of the rope be passive (two fixed end points).

Any suggestions would be greatly appreciated!

Thanks!



Replies: 0