AREA forums upgrade
Read more about the planned upgrade of our forums
  • 1/3
You are here: Forum Home / Autodesk® Smoke® / General Discussion / Audio w/ IMac...?
IMPORTANT ANNOUNCEMENT ABOUT AREA FORUMS
  RSS 2.0 ATOM  

Audio w/ IMac...?
Rate this thread
 
67365
 
Permlink of this thread  
avatar
  • floke
  • Posted: 24 May 2012 09:52 AM
  • Total Posts: 95
  • Joined: 27 December 2008 07:47 PM

In most, if not all, the promotional material I have seen for smoke 2013 the picture is of an
Imac w/a promise array...however, what you don’t see are speakers?

I know the Imac has built in speakers but what about running a pair of outboard speakers...? The best I can tell at this point is a mini jack in/out. I’ve ran that question up the Autodesk chain but so far no real great answers.

I hope I don’t have to use headphones...or buy a pile of peripheral gear to make this work.



Replies: 0
avatar

floke 24 May 2012 09:52 AM

In most, if not all, the promotional material I have seen for smoke 2013 the picture is of an
Imac w/a promise array...however, what you don’t see are speakers?

I know the Imac has built in speakers but what about running a pair of outboard speakers...? The best I can tell at this point is a mini jack in/out. I’ve ran that question up the Autodesk chain but so far no real great answers.

I hope I don’t have to use headphones...or buy a pile of peripheral gear to make this work.

Got Speakers?

KRK 8in. For a desktop system 6” would be fine, although these babies are gorgeous! A mixer in-between would be really professional for volume control too. ;^)

Cheers,
Mark



http://www.postmanvfx.com

Attachment Attachment
Replies: 0